International Association of Certified Home Inspectors|
#1
|
||||
|
||||
|
is there a minimum height requirement for a plumbing vent stack on a pitched roof? or a rule of thumb?
|
| Need a home inspection in Iowa? Check out InterNACHI's listing of Iowa certified home inspectors. Or, find a home inspector anywhere in the world with our inspection search engine. |
|
#2
|
|||
|
|||
|
Probably doesn't matter much in Florida. Main purpose is for snow levels blocking vent. But to answer your question, about a foot.
|
|
#3
|
||||
|
||||
|
Thanks, that is what I figured, I told the client is was not an issue ( he is a contractor himself). This one was just above the top edge of the flat cement tile above it. about an inch and a half
|
|
#4
|
||||
|
||||
|
Actually, I had that question myself and not to long ago. Florida Building Code Plumbing...I think its the 2002 code states in 904.1 that there needs to be 6 inches of clearance above the roof.
Comprehensive Building Consultants Naples Home Inspection, Naples Mold Inspection, Naples Radon Inspection, Bonita Springs Home Inspection, Bonita Springs Mold Inspection, Bonita Springs Radon Inspection. Donate here: or send checks to the Fl Home and Insurance Inspector Chapter 1103 W Hibiscus Blvd Ste 311 Melbourne, Fl 32901
|
|
#5
|
||||
|
||||
|
California Plumbing Code (based on the Uniform Code) is the same - 6 inch minimum projection.
IF YOUR INSPECTOR IS NOT USING THERMAL IMAGING, YOU'RE NOT GETTING THE WHOLE PICTURE ® Jeff PopeJPI Home Inspection Service Santa Clarita CA (661) 212-0738 Santa Clarita Home Inspection http://www.MyInspector.net |
|
#6
|
||||
|
||||
|
IRC is 6"
Kenton Shepard, InterNACHI member # 04082383 Certified Master Inspector (CMI) InterNACHI Director of International Development Director of Green Building EXPERT WITNESS SERVICE Conventional and Log homes (303) 717-8940
|
![]() |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| vent height | gkeene | Inspecting HVAC Systems | 6 | 9/12/10 1:45 AM |
| Pellet stove help | chellickson | General Inspection Discussion | 23 | 8/19/10 1:23 AM |
| Oil Vent Height | bsmith | Inspecting HVAC Systems | 2 | 4/30/09 11:14 AM |
| Air admittance valves everywhere | apfaff | Plumbing Inspections | 13 | 4/16/07 9:17 AM |
| Gas and oil hot water tank and Boiler Share Vents | hvanderbeek | Miscellaneous Discussion for Inspectors | 8 | 1/25/07 5:22 PM |