Check out Roy's NACHI plate cover, Bottom PIC.

http://www.nachi.org/plates.htm

Thanks to NACHI and Nick for the continuing great ideas that just keep comming .
Roy Cooke CMI…RHI…CHI…A Happy NACHI member

Some one asked me to explain my signs
What I did was go to the lumber store and buy Plexiglas cut it to fit my back window.
Went to sign place and had them letter it .
I open my back window and it sits in place and close window and there is my sign . I also did the same for me car and took a 2 inch piece 15 inches long of Aluminum from fascia bent the top 1/4 of an inch rolled down the window put sign against glass 1/4 inch aluminum over window and close the window sign stays in place .
Same for back widow of van set sign on bottom and slid a small piece of sign plastic 1*4 into top rubber.
If I need to go some place with out the signs they come out in ten seconds .
Because I like to go to the USA and if I have a business sign the customs ask a lot of questions no signs no questions .
New car move the signs no cost.

Nicely done Roy.

Thannks Nick,

Plate cover came in the mail today…

http://nachi.org/forum/attachment.php?attachmentid=6211&stc=1&d=1161196829

http://nachi.org/forum/attachment.php?attachmentid=6210&stc=1&d=1161196813

Wooo Hooo, Home Inspection can do this for you too !!

100_2309 (Small).jpg

100_2310 (Small).jpg

Nanci,

So where do you carry your ladder in that inspection mobile?:wink:

Do all Home Inspectors drive Vette’s?? LOL

Very nice Roy!! And good idea about removing them for travel!!

Licence sign looks good how do I get one?