- Federal Pacific Question.
- Fixture OK above Tub/Shower ?
- Undersized service wire
- How many GFCI's on a circuit?
- Bedroom w/o grounded outlets
- Stabeloc panel, approved use.
- Multiple wires at a bus bar screw
- Heat Pump wires feeding new gas furnace?
- Illumination of exterior door
- Looking at this panel
- arc fault knob & tube
- Capacity
- GFCI on 2 wire systems
- Alum 60 AMP on #6 AWG
- Great Stuff!!
- Re-Inspection
- power for gas cook top ignitors
- Double tap for surge/lightning protection
- 3 wire feeds to sub panels
- Metal switch on a breaker
- AFCI Breaker info...Question
- And you thought it couldn't be done...
- Main panel question, house built 1960
- Why did they use Low Voltage Inside wiring ???
- Bonding sub panel
- Height of garage door photocells
- Ceiling Fans
- Conduit (proper or improper)
- Do I need to mention this...
- Amerage question
- Equipment panels
- Here's an old FPE panel...
- Bonding Jumper Size???
- Flex conduit approved for exterior use???
- Chandelier over jacuzzi
- Code in Mobile homes
- Aluminum wiring to copper
- Today's Daily Door Prize! First Member to Reply Wins!
- Pigtailing SEC
- on demand HWT- GFCI ?
- Can you help me with an Inspection problem?
- Exposed romex in garage below 7 feet. (help)
- Main Panel vs Sub-Panel and main disconnect?
- AFCI white wire - gnd or ntrl?
- sub panel ?
- Pool pump bonding
- System overload ?
- Another Square D Breaker Question
- For Sale
- GFCI
- CPSC -----> Recall on electric meter panels
- GFI question
- AFCI question
- More Great Ozark Electrical Engineering
- Spray insulated romex
- Electrical device ...please help. pic included
- Grounding
- Four pin outlet?
- Aluminum ground wire in Main Panel ? (Pics)
- Federal Pacific - The definitive answer
- Is this a problem???
- Should the Neutral lug be
- Dishwasher outlet directly under unit
- Cutler Hammer Breaker
- Letter to the Editor Knob & Tube Problem
- Grounding for TV Cable
- Ground not bonded to neutral in main panel?
- GFCI Question
- Is this for the doorbell?
- All I can say is wow...
- SOP requirement
- What is this
- AFCIs...a solution to aluminum wiring?
- Todays Inspection I think a upgrade may be needed
- Ground/Nuetral tie bar
- Grounding Question
- Ok to groung panel to gas line?
- Question on swimming pool lights
- Upgraded 220 panel with 110 receptacles?
- "Live" Knob and Tube
- Horizontal GFCI outlet
- Surge Arrestor Installation
- Frayed Service Wires
- What were they thinking?
- Meter to panel question
- No Drip Loop
- Dueling Suretests
- Unusual outlet
- Creative wiring
- ?
- Dead front cover
- RV Electrical Hookup
- Need Inspector: EMF Testing, St.Cloud, MN.
- Grounding 2-prong outlets
- Distribution panel?
- Rotator Laser Level FOR SALE
- Copper, Aluminum and K&T
- using half a breaker
- Live Component?
- Double main
- Distribution panel neutral/ground separation question
- Bathroom outlets
- Hot breaker
- Folgers Coffe Has come out with a new product.
- Water in electrical panel
- another question on detatched building?
- Citizens Insurance Electrical Question
- Half Height Breaker Question
- describe this one
- Name that defect? Care to play?
- Help with wire connectors
- Outside outlet requirements
- Service size
- No lights
- Melted Wirenuts
- no room in fuse panel
- Sub-panel in detached building
- Put a band-aid on the problem
- Aluminum wire - rephrased
- Alu
- Still a GREAT mini presentation on Grounding/Bonding
- Aluminum wire
- Solid Aluminum for AC
- What does "open hot" mean?
- Is this aluminum?
- Multi-wire circuits: no handle ties
- False grounds & testing receptacles
- Federal Block fuses
- Pierce "knife blade" Cartridge fuses
- Sealant on Breakers
- What is it?
- Odd grounding question.
- murray = square D?
- ACFI for one bedroom
- Interesting 120V Sub Panel
- 4 wire for main panel?
- GFCI and whirlpool tub
- Thinking of a New Book - Give your thoughts
- Help II
- Help!
- Dryer OCPD breaker and fuses.
- Double tap 30 amp, 240 for dryer dryer
- Double Tapping Main Lugs
- Sanity Check
- Disconnect at the exterior
- 2 Service Disconnects
- GFCI circuit breaker
- Clearence for service wire
- Sub panel ground
- OK Construction Industries Board approves InterNACHI's FREE online Electrical course.
- Service Drop Within Reach of Deck
- Garage Wall switch ?
- Panel Cover
- Submersible pump wiring
- Ceiling fan wiring...need info.
- Open Neutral ??
- Siemens distribution panel bonding screw installation
- Yes or No twofer ???
- Two disconnects
- Detached Building Sub Panel
- Recommend changes, or call as deficient?
- Where did the wires go?
- Split nut connection
- Question Regarding Panel
- Truth and Facts about AL Wiring-Enjoy
- Is this bonded?
- All "How to Perform Electrical Inspections" book back-orders have been shipped.
- Older panel...need recommendation
- Hot Breaker
- Yes Power is on. To Kill you
- A "builder's Home"
- How many EGC under one screw?
- 2 prong
- CSST bonding poll
- Ground Clamp
- Service entry question
- Light/shower
- Zinsco panel problems are myth...
- Harry Homeowner Stikes Again!
- FP Panels Today Please Assit
- Oversized wire
- Two meters three services......
- 1/0 Service Entry on 200 amp Panel
- Picture of mouse in panel
- Interesting Brown Discoloration
- Commercial Panel
- Stranded/solid
- Grounding strap to panel
- 210.52[C][3]- The Peninsular Project
- Zinsco panels--do you remove the covers from exterior panels?
- Outdoor lighting mounted on eaves..question
- Perhaps an upgrade is in order???
- doubletap question
- AL Wiring
- Popping Sound?
- Shunt trip breaker
- How do I write this up????
- Eaton Breakers?
- disposal wiring
- I just finished watching NACHI.TV's best educational episode. Thanks Paul!
- Knob and Tube Wiring: Please proof this new inspection article.
- Do you check exterior floodlights?
- UF and a plug?
- Sq. D. in Challenger panel
- Hey Paul, here is a good one
- Garbage Disposal Wiring
- 2008 NEC Change-Panelboard circuit limitations relaxed
- Draft of 2011 NEC
- Every Day is New Adventure - Someone's Method of Bonding?
- Hot breaker
- Electrical Inspection Training Video
- Aluminum wire questions
- Repair of conduit
- Capped white
- ? for the gurus - Romex coloring
- Frderal Pacific main panels
- Sub Panel
- Crouse-Hind panel
- Crause-Hinds breakers
- plastic wire gauge tool
- 30 amp/220v outlet installed in kitchen cabinet above stove
- Main panel installed at floor level in garage
- What electrical concerns/defects do you see?
- InterNACHI's new Electrical Inspections book coming soon.
- Wire supports
- Breaker conductor size
- More issues
- Subpanel issues
- Bulldog Pushmatic panel main bus bar terminals
- Service panel
- Voltage drop
- bonding
- Happy birthday Paul Abernathy.
- zinsco panel
- Meter load
- Know what this is?
- panel inside garage...why? pic included
- Interesting Electric panel
- Breaker application
- a
- Not seen a panel like this one before...
- Panel Issues
- Do you call out a deck that has no receptacle?
- Deck Receptacles. Please proof this new article.
- What the heck is this for
- What is it and what's it doing in my electrical panel?
- Play the new online Inspector Challenge Game. Electrical. Free. For fun only.
- Consider as SE Panel or Sub Distribution ?
- What is the highest voltage drop you've worked around?
- double tapped with wire nuts