View Single Post
 
Old 1/2/10, 3:46 PM
bking's Avatar
bking bking is offline
Certified Professional Inspector (CPI)
 
Join Date: Jan 2005
Location: Mt Pleasant SC
Posts: 3,407
Default Re: Heat pump operation

What do you mean by "mine is set to 30 degrees" ?

Is that when it switches over to an aux heat source?

Heat pump operation depends on the type of refrigerant, the newer R410 is much better since it is used in units that have other advanced designs.

At 15 deg F, some heat can be absorbed from the exterior but most likely it was running in regular and aux heat strip mode at the same time if you had good warm air. If you had the t-stat up over 2 degrees it would have been running the electric strips also unless programmed out via a special t-stat that also uses an exterior temp sensor. Some units can even sense that the house is not gaining any heat and will add in the aux strips even at a one degree t-stat command.



B.A. King Home Inspections, LLC
www.BAKingHomeInspections.com
Serving Charlotte NC area and Fort Mill SC areas.
CMI Certified Master Inspector and Independent
License NC2449 and SC1597



"Discovery consists in seeing what everyone else has seen and thinking what no one else has thought."
- Albert Szent-Gyvrgyi, Nobel Prize for Medicine 1937
Reply With Quote