This is the top peak of a shed roof, I think that the flashing should be on top od the shingles. Any comments.
sorry about the pic posting
It works better leaving the metal exposed. If they would have ran a ridge cap sideways with a 1 inch overhang on the top edge, it would have been better and still covered the metal.
I’m with you on this. See Page 64, Figure 6-16, ‘Topping off flashing on a single pitch roof’ of Certainteed Shingle Applicator’s Manual: http://www.certainteed.com/NR/rdonlyres/C02361B8-67C4-4A26-8CAB-EF54D6FC1A47/0/SAMv7_ch6_Flashing_etc.pdf
