New construction - spaces in wood framing and warped wood

Hello Everyone.

New construction home (pre drywall) Noticed the following:

  • large gaps/Spacing between wood framing
  • Warped wood on second-floor hallway
  • Above garage ceiling wood framing the one piece of wood is bent at the end

Will this be a concern and need to be corrected before the drywall goes in? See Photos
http://clip2net.com/s/3OaguEa
http://clip2net.com/s/3OagHuP
http://clip2net.com/s/3OagM75
http://clip2net.com/s/3OagUJM
http://clip2net.com/s/3Oah9mb
http://clip2net.com/s/3Oahmht

http://clip2net.com/s/3OaguEa

http://clip2net.com/s/3OagHuP

http://clip2net.com/s/3OagM75

http://clip2net.com/s/3OagUJM

http://clip2net.com/s/3Oah9mb

http://clip2net.com/s/3Oahmht

What photo’s ?

Pictures would be nice. You are not so eloquent that I am able to visualize the issue.

Sorry guys, I inserted the images, but they seemed to not have posted. Here are thelinks to the Images:

Garage: http://clip2net.com/s/3OaguEa

Gaps:
http://clip2net.com/s/3OagHuP
http://clip2net.com/s/3OagM75
http://clip2net.com/s/3OagUJM

Warped wood on hallway 2nd FL:
http://clip2net.com/s/3Oah9mb
http://clip2net.com/s/3Oahmht

  • Not concerned with the warped I-joist.

  • Gaps in the subfloor is sloppy work. Shouldn’t be a problem depending on what finish is being installed. Hardwood, no problem. Tile, no problem as they’ll put down a layer of cement board first. Carpet, most likely a problem if they don’t put down some underlayment. Vinyl (other), a problem if they don’t put down some underlayment.

  • Un-level floor in upper hall. They better level it out with some framing/blocking from below.

  • Gap between wall studs. Looks like they ran the sheathing vertically instead of horizontally. I always ran the sheathing horizontally after the framing was complete so I never had that situation. Some framers build the walls and install the sheathing first and then raise the walls. Maybe they raised that wall in two sections. I can’t tell from that photo. Would need to see the top plate(s). Make sure those two studs are securely fastened together and I’d throw some insulation between.

Thank you Stephen. In your experience have you came across OSB floor board creaking later on or having problems?

Really afraid of the floor upstairs creaking later down the road, especially in the hallway. In the model home the hallway was already creaking which was not a reassuring sign.

I agree with Steven. Just remember it is a lot easier to fix these issues now

If they glued the subfloor, there shouldn’t be a problem. Construction adhesive has been required for decades. Look at the top of the floor joists where the subfloor meets. You should be able to see adhesive squeezed out in some areas.