Go Back   InterNACHI Inspection Forum >

Notices

Showing results 1 to 25 of 150
Search took 0.01 seconds.
Search: Posts Made By: snadeau
Forum: Inspection Question of the Week 3/24/19, 10:25 AM
Replies: 6
Views: 53
Posted By Steve Nadeau
Re: Questions of the week of 03/24/19

1 D
2 A
3 C
4 T

Bonus The Shaggs
Forum: Inspection Question of the Week 3/23/19, 11:07 AM
Replies: 20
Views: 290
Posted By Steve Nadeau
Re: Questions of the week 03/17/2019

Thanks - gotta have brick slippage to go wit cher granite lippage ;)
Forum: General Inspection Discussion 3/22/19, 6:49 PM
Replies: 23
Views: 426
Posted By Steve Nadeau
Re: Death Trap

Code shouldn't cover Darwin Award winners.
Forum: Inspection Question of the Week 3/18/19, 11:17 PM
Replies: 20
Views: 290
Posted By Steve Nadeau
Re: Questions of the week 03/17/2019

1. To hold the bottom edge in place and make a flashing channel to capture any moisture that gets behind the brick veneer. In conjunction with the moisture barrier, the poly will guide the water to...
Forum: Electrical Inspections 3/17/19, 4:06 PM
Replies: 30
Views: 480
Posted By Steve Nadeau
Re: Double-tapped Square D

This has been a very informative post. I've always just looked at the pressure plate on Square D's to determine if they could take two (that way I don't have to put on my readers).

And, in the...
Forum: Inspection Question of the Week 3/5/19, 1:11 PM
Replies: 17
Views: 359
Posted By Steve Nadeau
Re: MembersAskTheQuestions 2-27-19

Ooh. That would be bad, very bad.

Tell you what Roy. Since you're calling BS, We'll let you hold onto some buried cable in between the two while we run a few thousand volts into them ground...
Forum: Inspection Question of the Week 2/28/19, 1:18 PM
Replies: 17
Views: 359
Posted By Steve Nadeau
Re: MembersAskTheQuestions 2-27-19

1) Under fault conditions in the hookup of two ground rods, resistance to earth can be far too high to trip the circuit breaker - and the soil resistance between separate ground rods can allow...
Forum: Inspection Question of the Week 2/18/19, 11:01 PM
Replies: 14
Views: 224
Posted By Steve Nadeau
Re: Questions of the week of 02/17/19

Wow! Thanks!

I learned a thing or two about wells building customs in the Rockies, and I learned even more from researching your questions!
Forum: Inspection Question of the Week 2/17/19, 11:15 AM
Replies: 14
Views: 224
Posted By Steve Nadeau
Forum: Inspection Question of the Week 2/12/19, 3:20 PM
Replies: 24
Views: 405
Posted By Steve Nadeau
Re: Questions of the week of 02/10/19

oOO0Hhh! Sunday Funday! Looking forward to it. sir. I think we all know that there are almost always more than one authoritative site, and like home inspectors, they don't always agree!

Thanks -
Forum: Inspection Question of the Week 2/10/19, 1:01 PM
Replies: 24
Views: 405
Posted By Steve Nadeau
Forum: Inspection Question of the Week 2/7/19, 10:53 PM
Replies: 20
Views: 381
Posted By Steve Nadeau
Forum: Inspection Question of the Week 2/4/19, 9:13 AM
Replies: 20
Views: 381
Posted By Steve Nadeau
Re: QuestionsOfWeek February 2 2019

1) D
2) B
3) C
4) Diameter
5) Nerves
Forum: Inspection Question of the Week 2/1/19, 9:32 AM
Replies: 25
Views: 534
Posted By Steve Nadeau
Re: QuestionsOfWeekJanuary 26 2019

Real head scratchers - I'm going to figure out how to make a cucumber necklace
Forum: Inspection Question of the Week 1/27/19, 2:20 PM
Replies: 25
Views: 534
Posted By Steve Nadeau
Re: QuestionsOfWeekJanuary 26 2019

1 - B
2 - C
3 - drip loops
4 - chili peppers (tricky man)
5 - F
Bonus - Hank Thompson!
Forum: Inspection Question of the Week 1/24/19, 10:59 PM
Replies: 26
Views: 552
Posted By Steve Nadeau
Re: Questions of the Week January 17

I think they were just right - good head scratchers.
It helps if you link to your sources for the answers when you give them though (from a learning aspect).
Forum: Inspection Question of the Week 1/23/19, 1:35 PM
Replies: 26
Views: 552
Posted By Steve Nadeau
Re: Questions of the Week January 17

That certainly was a tough one - thanks.
Forum: Inspection Question of the Week 1/17/19, 5:36 PM
Replies: 26
Views: 552
Posted By Steve Nadeau
Re: Questions of the Week January 17

1 - c. 110 degrees F
2 – b. The main fuses have a higher rating than the service entrance wire.
3 – d. All of the above.
4 – d. Wood shakes
5 – a. Caused by improper appliance venting
Forum: Contractors Forum 1/17/19, 11:42 AM
Replies: 18
Views: 2,704
Posted By Steve Nadeau
Re: where is the ethical line between contractor and inspector

I think that "repairs or associated services" has quite a bit of wiggle room. If you inspect a home that is missing insulation as it's only defect, ethically you can't sell your client insulation. I...
Forum: Structural Inspections 1/17/19, 11:21 AM
Replies: 17
Views: 421
Posted By Steve Nadeau
Re: Looking for affirmation of what I think I called out correctly

I'm used to framing for significant snow loads. To me, the "purlin" header looks inadequate even if you were to add hangers to support the upper sections of rafters. Definitely ask the seller to...
Forum: Inspection Question of the Week 1/10/19, 10:49 AM
Replies: 20
Views: 440
Posted By Steve Nadeau
Re: QuestionsOfWeek January 9 2019

1. A
2.Conduction
3.True
4. H
5. True
Forum: Inspection Question of the Week 12/21/18, 10:56 AM
Replies: 35
Views: 907
Posted By Steve Nadeau
Re: Questions of the week of 12/16/18

Great questions Paul, and hope this coming year finds you in excellent health -
Forum: Inspection Question of the Week 12/16/18, 4:37 PM
Replies: 35
Views: 907
Posted By Steve Nadeau
Re: Questions of the week of 12/16/18

1 F
2 B
3 ABCD
4 D
Bonus: Keith OMG Richards
Forum: Inspection Question of the Week 12/14/18, 2:21 PM
Replies: 16
Views: 602
Posted By Steve Nadeau
Re: QuestionsOfWeek December 11

1) A

2) B

3) Static electricity

4) Resistor

5) C
Forum: Inspection Question of the Week 11/9/18, 2:38 PM
Replies: 33
Views: 1,093
Posted By Steve Nadeau
Re: Questions of the Week, November 5, 2018

I'm awaiting the "Ollie Ollie In-Come-Free!" shoutout for us five time winners...
Showing results 1 to 25 of 150

 
All times are GMT -4. The time now is 8:08 PM.